A. Locate the 3 small switch blanks left of the steering column, and the left most blank. B. Carefully drill a 5 / 16 ” diameter hole centered in the switch blank. C. Remove the knurled mounting nut from the back of the switch, pass the wires through the hole, then secure the switch with the knurled nut 2. Preparing the L.E.D. / Valet Switch : A. Locate the 4 pin Molex connector found in the hardware bag included in the kit. B. Carefully plug the terminals at the ends of the 4 wires from the switch into the connector housing as shown
↧
